| b High-Speed Response, POL DC-DC Converter |
Ultra Small Size, Able to drive the Latest Digital LSI with High-Speed
Load Response!
BSV-H Series
High-Speed Response POL DC-DC Converters/BSV-H Series
High-Speed Response, POL Converter
InputF3V-5.5V @@@OutputF3.3V [0.8V-3.3V]
|
 |
|
|
 |
| Voltage can be optionally set with external resistors.(Ex.: 0.8V, 1V, 1.2V, 1.5V, 1.8V, 2V, 2.5V, 3.3V) |
| - Ultra Small Size@16.5×27mm |
| - Low Profile@4.2mm |
| - High-Speed Response |
| - Ultra High Efficiency |
| - Built-in Over-Current Protection |
| - External Capacitorts Not Required |
| - Heat Sink Not Required |
| - Non-Isolated Type |
| - Built-in Low Input Voltage Protection |
| - Remote ON/OFF Control |
| - Adjustable Output Voltage |
| - Surface Mount Package (SMD) |
- Operating Temp. Range@
-40 to +85
(Temp. derating required) |
| - RoHS Compliance |
- Note!
@This is an outline of the products.
@When in designing, be sure to
refer to the data sheets.
|
l
BSV-H Series |
h u
Vdc |
n u
Vdc |
n h
A |
Output ADJ
Vdc |
Ripple m
mVpp(typ.) |
di
(typ.) |
| BSV-3.3S12R0H |
3.0-5.5 |
3.3 |
0-12 |
0.8-3.3 |
30 |
93 |
| Note 1: The input and output voltage difference needs to be 0.5V or more.
Vin(V)-Vo(V)0.5V |
| Note 2: Ripple noise, efficiency value is when input voltage is at 5V. |
| Note 3: Ripple noise is measured at 20MHz bandwidth. |
| Note 4: Depending on the ambient air temp. cpnditions, air flow is required. |
<Outline>
@@
@@ |
@@
Weight:@3.1g typ.
Dimensions:@mm
Tolerances:@±0.5@@ |
<Standard Connection Circuit Diagram>
- SW1: Output goes OFF when in short.
-
Trim: Rating output voltage when in open.
-
R1: When adjusting the output voltage, connect R1 between Trim pin and
-Sense pin.
|
|
|
|
|